Titan 4WD V8-5.6L (VK56DE) (2006)
4. Install new O-ring in A/T assembly harness connector.
NOTE:
^
Do not reuse O-ring.
^
Apply ATF to O-ring.
5. Install A/T fluid temperature sensor 2 to bracket.
6. Install A/T fluid temperature sensor 2 (with bracket) in control valve with TCM. Tighten A/T fluid temperature sensor 2 bolt to the specified
torque. Refer to "Components". See: Automatic Transmission/Transaxle/Service and Repair/Overhaul (Component Parts)/Components
CAUTION: Adjust bolt hole of bracket to bolt hole of control valve with TCM.
7. Install control valve with TCM in transmission case.
CAUTION:
^
Make sure that turbine revolution sensor securely installs turbine revolution sensor hole.
^
Hang down revolution sensor harness toward outside so as not to disturb installation of control valve with TCM.
^
Adjust A/T assembly harness connector of control valve with TCM to terminal hole of transmission case.
^
Assemble it so that manual valve cutout is engaged with manual plate projection.