Titan 4WD V8-5.6L (VK56DE) Flex Fuel (2009)
Transfer Case Actuator: Service and Repair
TRANSFER CONTROL DEVICE
Removal and Installation
REMOVAL
1. Switch the 4WD shift switch to 2WD and set the transfer assembly to 2WD.
2. Disconnect the transfer control device connector.
3. Remove the breather hose from the transfer control device.
4. Remove the bolts and detach the transfer control device.
INSTALLATION
1. Install the new O-ring to the transfer control device.
CAUTION:
-
Do not reuse O-ring.
-
Apply petroleum jelly to O-ring.
2. Install the transfer control device.
a. Turn the control shift rod fully counterclockwise using a flat-bladed screwdriver, and then put a mark on the control shift rod.