Titan 4WD V8-5.6L (VK56DE) Flex Fuel (2009)
Memory Positioning Module: Service and Repair
Automatic Drive Positioner Control Unit
AUTOMATIC DRIVE POSITIONER CONTROL UNIT
Removal and Installation
CAUTION:
When removing and installing, use shop cloths to protect parts from damage.
REMOVAL
1. Disconnect the battery negative terminal.
2. Remove the instrument driver lower panel. Refer to See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Instrument Lower Panel LH.
3. Remove the screw from the automatic drive positioner control unit (1).
4. Remove automatic drive positioner control unit (1) from bracket and disconnect electrical connectors.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Clamp the harness in position.
NOTE:
After installing the automatic drive positioner control unit, perform additional service when disconnecting battery negative terminal. Refer to See:
Accessories and Optional Equipment/Memory Positioning Systems/Testing and Inspection/Programming and Relearning.