nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Ignition Relay > < Ignition Control Module|Description and Operation|Page 9254
Page 2
background image

Spark should be generated.

CAUTION:
-

Do not approach to the spark plug and the ignition coil within 50cm. Be careful not to get an electrical shock while checking, because the
electrical discharge voltage becomes 20kV or more.

-

It might cause to damage the ignition coil if the gap of more than 17 mm is taken.

NOTE:  When the gap is less than 13 mm, the spark might be generated even if the coil is malfunctioning.

17. If NG, Replace ignition coil with power transistor.

CONDENSER-1

1. Turn ignition switch OFF.
2. Disconnect condenser harness connector.

3. Check resistance between condenser terminals 1 and 2.

Resistance................................................................................................................................................................Above 1 MOhms at 25 °C (77 °F)

Ignition Relay > < Ignition Control Module|Description and Operation|Page 9254