Xterra 4WD V6-3.3L SC (VG33ER) (2003)
Impact Sensor: Service and Repair
Satellite Sensor
SIDE AIR BAG (SATELLITE) SENSOR
Removal and Installation
REMOVAL
CAUTION: Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
1. Remove seat belt pre-tensioner. See: Seat Belt Systems/Seat Belt Tensioner/Service and Repair
2. Remove side air bag (satellite) sensor fixing nuts.
3. Remove the side air bag (satellite) sensor connector.
CAUTION:
-
Do not use old nuts; replace with new ones.
-
Check side air bag (satellite) sensor to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it with
new one.
-
Do not attempt to disassemble side air bag (satellite) sensor.
-
Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.
INSTALLATION
To install, reverse the removal procedure.
CAUTION:
-
Check side air bag (satellite) sensor for proper installation.
-
After replacement of side air bag (satellite) sensor, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS Operation
Check". See: Air Bag Systems/Testing and Inspection/Component Tests and General Diagnostics