Xterra 4WD V6-4.0L (VQ40DE) (2009)
Trim Panel: Service and Repair
Removal and Installation
BODY SIDE TRIM
Removal and Installation
LOWER DASH SIDE FINISHER
Removal
1. Remove front door welt.
2. Remove front kick plate.
3. Remove pushpin, release the clips and remove lower dash side finisher.
Installation
Installation is in the reverse order of removal.
CENTER PILLAR LOWER FINISHER
Removal
1. Remove front and rear door welts.
2. Remove seat belt anchor. Refer to See: Restraint Systems/Seat Belt Systems/Child Restraint/Child Seat Tether Attachment/Service and
Repair/Latch (Lower Anchors And Tether For Children) System.
-
On RH side, disconnect seat belt tension sensor.
3. Remove front and rear kick plates.
4. Remove center pillar lower finisher.
Installation
Installation is in the reverse order of removal.
CENTER PILLAR UPPER FINISHER
Removal
1. Remove center pillar lower finisher.
2. Remove seat belt shoulder anchor and D-ring. Refer to See: Restraint Systems/Seat Belt Systems/Child Restraint/Child Seat Tether
Attachment/Service and Repair/Latch (Lower Anchors And Tether For Children) System.
3. Remove center pillar upper finisher.
Installation
Installation is in the reverse order of removal.
FRONT PILLAR LOWER FINISHER
Removal
1. Remove front door welt.
2. Remove front kick plate.
3. Remove the front pillar lower finisher.
Installation
Installation is in the reverse order of removal.
FRONT PILLAR UPPER FINISHER
Removal
1. Remove the front pillar lower finisher.
2. Remove the front pillar assist grip bolts and assist grip.
3. Remove the front pillar upper finisher.
Installation
Installation is in the reverse order of removal.
KICK PLATES
Removal
Release clips and remove front and/or rear kick plates.