Xterra SE 2WD V6-3.3L (VG33E) (2002)
/Page-1835003.png)
4. Connect red clip of deployment tool [SST: KV99106400 (J38381)] to battery positive terminal and black clip to negative terminal.
5. The right side lamp on the deployment tool [SST: KV99106400 (J38381)], marked "DEPLOYMENT TOOL POWER", should glow green, not
red.
6. Press the button on the deployment tool [SST: KV99106400 (J38381)]. The left side lamp on the deployment tool [SST: KV99106400 (J38381)],
marked "AIR BAG CONNECTOR VOLTAGE", will illuminate and the air bag module or seat belt pre-tensioner will deploy.
Disposing of Air Bag Module and Seat Belt Pre-Tensioner
-
Before disposing of air bag modules and seat belt pre-tensioners, or vehicles equipped with such systems, deploy the systems. If such systems have
already been deployed due to an accident, dispose of as indicated in "DISPOSING OF AIR BAG MODULE AND SEAT BELT
PRE-TENSIONER".
-
When deploying air bag module or seat belt pre-tensioner, always use the Special Service Tool; Deployment tool KV99106400 (Kent-Moore No.
J38381).
-
When deploying air bag module or seat belt pre-tensioner, stand at least 5 m (16 ft) away from the deployment component.
-
When deploying air bag module or seat belt pre-tensioner, a fairly loud noise is made, followed by smoke being released.
The smoke is not poisonous, however, be careful not to inhale smoke as it irritates the throat and can cause choking.
-
Only activate one air bag module or seat belt pre-tensioner at a time.
-
Due to heat, leave air bag module unattended for more than 30 minutes after deployment. Leave seat belt pre-tensioner unattended for more than
10 minutes after deployment.
-
Be sure to wear gloves when handling a deployed air bag module or seat belt pre-tensioner.
-
Never apply water to a deployed air bag module or seat belt pre-tensioner.
-
Wash your hands clean after finishing work.
-
Place the vehicle outdoors with an open space of at least 6 m (20 ft) on all sides when deploying air bag module or seat belt pre-tensioner while
mounted in vehicle.
-
Use a voltmeter to make sure the vehicle battery is fully charged.
-
Do not dispose of the air bag module or seat belt pre-tensioner undeployed.
DISPOSING OF AIR BAG MODULE AND SEAT BELT PRE-TENSIONER
Deployed air bag modules and seat belt pre-tensioners are very hot. Before disposing of air bag modules and seat belt pre-tensioners, wait at least 30
minutes and 10 minutes, respectively Seal them in a plastic bag before disposal.
CAUTION:
-
Never apply water to a deployed air bag module or seat belt pre-tensioner.
-
Be sure to wear gloves when handling a deployed air bag module or seat belt pre-tensioner.
-
No poisonous gas is produced upon air bag module or seat belt pre-tensioner deployment. However, be careful not to inhale gas since it irritates
the throat and can cause choking.
-
Do not attempt to disassemble air bag module or seat belt pre-tensioner.
-
Air bag module or seat belt pre-tensioner cannot be reused.
-
Wash your hands clean after finishing work.
