Xterra SE 4WD V6-3.3L (VG33E) (2000)
/Page-1895013.png)
Loading Procedure
NOTE:
-
The CONSULT-II must be used in conjunction with a program card. Consult-II does not require loading (Initialization) procedure.
-
Be sure the CONSULT-II is turned off before installing or removing a program card.
Nickel Metal Hydride Battery Replacement
CONSULT contains a lithium battery. When replacing the battery, do the following:
WARNING: Replace the lithium battery with SANYO Electric Co., Ltd., CR2032 only. Use of another battery may present a risk of fire or
explosion. The battery may present a fire or chemical burn hazard if mistreated. Do not recharge, disassemble or dispose of in fire.
Keep the battery out of reach of children and discard used battery conforming to the local regulations.
Ground Inspection
Ground connections are very important to the proper operation of electrical and electronic circuits. Ground connections are often exposed to moisture,
dirt and other corrosive elements. The corrosion (rust) can become an unwanted resistance. This unwanted resistance can change the way a circuit works.
Electronically controlled circuits are very sensitive to proper grounding. A loose or corroded ground can drastically affect an electronically controlled
circuit. A poor or corroded ground can easily affect the circuit. Even when the ground connection looks clean there can be a thin film of rust on the
surface. When inspecting a ground connection follow these rules:
1. Remove the ground bolt screw or clip.
2. Inspect all mating surfaces for tarnish, dirt, rust, etc.
3. Clean as required to assure good contact.
4. Reinstall bolt or screw securely.
5. Inspect for "add-on" accessories which may be interfering with the ground circuit.
6. If several wires are crimped into one ground eyelet terminal, check for proper crimps. Make sure all of the wires are clean, securely fastened and
providing a good ground path. If multiple wires are cased in one eyelet make sure no ground wires have excess wire insulation.
Harness Connector
