Xterra SE 4WD V6-3.3L (VG33E) (2000)
5. Detach spider assembly with press.
6. Draw out boot.
Cover drive shaft serration with tape to prevent damaging the boot.
Wheel Side (ZF100)
CAUTION: The joint on the wheel side cannot be disassembled.
^
Before separating joint assembly, put matching marks on drive shaft and joint assembly.
^
Separate joint assembly with suitable tool.
Be careful not to damage threads on drive shaft.
^
Remove boot bands.
INSPECTION
Thoroughly clean all parts in cleaning solvent, and dry with compressed air. Check parts for evidence of deformation and other damage.
Drive Shaft
Replace drive shaft if it is twisted or cracked.
Boot
Check boot for fatigue, cracks and wear. Replace boot with new boot bands.
Joint Assembly (Final drive side)
^
Replace any parts of double offset joint which show signs of scorching, rust, wear or excessive play.
^
Check serration for deformation. Replace if necessary.
^
Check slide joint housing for any damage. Replace if necessary.
Joint Assembly (Wheel side)
Replace joint assembly if it is deformed or damaged.
ASSEMBLY