Xterra XE 2WD V6-3.3L (VG33E) (2000)
/Page-1048001.png)
Crankshaft Position Sensor: Testing and Inspection
1. Disconnect crankshaft position sensor (OBD) harness connector.
2. Loosen the fixing bolt of the sensor.
3. Remove the sensor.
4. Visually check the sensor for chipping.
5. Check resistance as shown in the figure.
Resistance: Approximately 166.5 - 203.5 (ohms) [at 20 °C (68 °F)]
If NG, replace crankshaft position sensor (OBD).
