Xterra XE 2WD V6-3.3L (VG33E) (2000)
/Page-1597001.png)
Wheel Bearing: Testing and Inspection
Front
FRONT WHEEL BEARING
^
Check that wheel bearings operate smoothly.
^
Check axial end play.
Axial end play: 0 mm (0 inch)
^
Adjust wheel bearing preload if there is any axial end play or wheel bearing does not turn smoothly.
Preload Adjustment (2WD models)
Adjust wheel bearing preload after wheel bearing has been replaced or front axle has been reassembled.
1. Before adjustment, thoroughly clean all parts to prevent dirt entry.
2. Apply multi-purpose grease sparingly to the following parts:
^
Threaded area of spindle
^
Contact surface between lock washer and outer wheel bearing
^
Hub cap (as shown) 18 - 22 g (0.63 - 0.78 oz)
^
Grease seal lip
3. Tighten wheel bearing lock nut to the specified torque.
34 - 39 Nm (3.5 - 4.0 kg-m, 25 - 29 ft. lbs.)
4. Turn wheel hub several times in both directions to seat wheel bearing correctly.
5. Again tighten wheel bearing lock nut to the specified torque.
34 - 39 Nm (3.5 - 4.0 kg-m, 25 - 29 ft. lbs.)
