Xterra XE 4WD V6-3.3L SC (VG33ER) (2002)
-
Pay attention so as not to scratch cylinder when installing pistons.
Inspection
DRUM
Maximum inner diameter (Repair limit): 296.5 mm (11.67 inch)
-
Contact surface should be fine finished with No. 120 to 150 emery paper.
-
Using a drum lathe, lathe brake drum if it shows scoring, partial wear or stepped wear.
-
After brake drum has been completely reconditioned or replaced, check drum and shoes for proper contact pattern.
LINING
Measuring Brake Lining
Check lining thickness.
Standard lining thickness: 5.8 mm (0.228 inch)
Lining wear limit (A): 1.5 mm (0.059 inch)
Installation
Always perform shoe clearance adjustment.
-
Burnish the brake contact surfaces after refinishing or replacing drums or rotors, after replacing pads or linings, or if a soft pedal occurs at very
low mileage.
1. Fit toggle lever to brake shoe with retainer clip.
2. Shorten adjuster by rotating it.
-
Pay attention to direction of adjuster.