Xterra XE 4WD V6-3.3L SC (VG33ER) (2002)
/Page-2110028.png)
7. re-assemble all previously removed components in the reverse order you removed them.
^
Tighten the Fuel Sending Unit Inspection Cover Bolts snug, being careful not to strip out the plastic inserts.
^
Tighten the Body Cover Plate Bolts to 3.7 - 5.0 N-m (0.38 - 0.51 kg-m, 33.0 - 44.3 in-lb).
8. Start the vehicle and confirm proper engine running and fuel gauge operation.
Replace Fuel Sending Unit
Replace Fuel Sending Unit
WARNING:
^
Before performing any of the Service Procedures below, be certain there are no ignition sources (i.e., open flames, sparks, etc.) in or around the
vehicle/work area.
^
Make sure the appropriate rated fire extinguisher is available for immediate use.
^
Use suitable protective gloves, safety glasses, or face shield.
CAUTION:
Use suitable covers to protect carpet, upholstery, etc.
NOTE:
The Fuel Sending Unit that you remove from the vehicle may look different from the new replacement service part (see Figure 43).
1. If the fuel tank is more than 3/4 full, use a suitable device to remove fuel from the fuel tank until the fuel level is 3/4 full or less.
2. Release the fuel pressure from the fuel system using CONSULT-II (or other suitable method). Follow the procedure in the "EC" section of the Service
Manual.
3. Remove the Fuel Sending Unit as follows:
