Xterra XE 4WD V6-3.3L SC (VG33ER) (2002)
/Page-1452011.png)
A.
If a trail of corrosion from the ABS sensor hole cannot be seen inside the axle housing as shown in Figure C1:
^
Make a note on your Repair Order which judgement was made here.
^
The rear axle bearing does NOT need to be replaced.
^
Continue with step 2, below.
B.
If a trail of corrosion can be seen inside the axle housing as shown in Figure C2:
^
Make a note on your Repair Order which judgement was made here.
^
The rear axle bearing will have to be replaced.
^
Continue with step 2, below.
2.
Clean out all residual debris from the axle housing with a lint-free shop rag.
3.
If needed, remove all corrosion from the ABS sensor hole using suitable methods. You can use a wire brush, Emery cloth, an 18 mm ball hone,
etc. to do this.
