Achieva L4-138 2.3L SOHC VIN 3 MFI (1993)
Stabilizer Shaft - Lower (Outer) See Figure 1.
Remove Or Disconnect
1.
Raise vehicle and support body with jack stands. Refer to Section 0A.
2.
Insulator nuts and isolator clamps.
3.
Lower stabilizer shaft.
Install or connect
1.
Lower stabilizer shaft.
2.
Insulator nuts and isolator clamps. Tighten insulator nuts to 22 N-m (16 lbs.ft.). Tighten isolator clamps to 3.75 N-m (33 lbs.in.).
3.
Lower vehicle.
Stabilizer Shaft - Upper (Inner) See Figure 1.
Remove Or Disconnect
1.
Raise vehicle and support body with jack stands. Refer to Section 0A.
2.
Lower stabilizer shaft. Refer to "Stabilizer Shaft - Lower, in this section.
3.
Nuts and bolts.
4.
Upper stabilizer shaft.
Install Or Connect
1.
Upper stabilizer shaft.
2.
Nuts and bolts. Tighten nuts to 22 N-m (16 lbs.ft.).
3.
Lower stabilizer shaft. Refer to "Stabilizer Shaft - Lower, in this section.
4.
Lower vehicle.
SECTION 5-5F
Brake system, hose and cable routing: will not change.
SECTION 6A7
The W41 camshaft has a different profile than the standard 2.3L camshaft. There is no affect on service procedures.
SECTION 6D3
Improved durability generator. There is no affect on service procedures.
SECTION 6F
