Achieva L4-138 2.3L SOHC VIN 3 MFI (1993)
INSTALL OR CONNECT
1. Case cover.
TIGHTEN
^
Case Cover Bolts to 24 Nm (18 lb. ft.).
2. Check balls into case cover.
3. Spacer plate and gaskets.
4. Pump drive shaft.
5. Check ball into control valve assembly.
6. Auxiliary valve body and control valve assembly onto transaxle.
7. TCC wire to case electrical connector.
8. Valve body cover and gasket.
INSPECT
^
Bolts: to determine if the washer is inverted.
IMPORTANT
^
Use adhesive/sealant compound GM P/N 12345282 or equivalent to reduce the potential for fluid leaks on bolts.
9. Transaxle bracket.
10. Transaxle mount to transaxle bracket. Do not tighten until mount is fastened to body.
11. Raise engine/transaxle assembly.
