Achieva L4-144 2.4L DOHC VIN T SFI (1996)
Knock Sensor: Service and Repair
Knock Sensor
REMOVE OR DISCONNECT
1. Disconnect the negative battery cable from the battery.
2. Raise the vehicle and suitably support.
3. Disconnect the Knock Sensor (KS) wiring harness connector from the knock sensor.
4. Remove the knock sensor (1) from the engine block.
INSTALL OR CONNECT
1. Clean the threads thoroughly. Install the knock sensor (1) into the engine block.
-
Tighten the knock sensor to 16-22 N.m (143-196 lb. in.).
2. Connect the KS wiring harness connector to the knock sensor.
3. Lower the vehicle.
4. Connect the negative battery cable to the battery.
