Achieva L4-144 2.4L DOHC VIN T SFI (1996)
Ignition Control Module: Service and Repair
Ignition Control Module Assembly
REMOVE OR DISCONNECT
1. Disconnect the negative battery cable.
2. Disconnect the electronic Ignition Control Module (ICM) 11 pin harness connector.
3. Remove the ignition coil and the electronic ignition control module assembly to camshaft housing bolts.
CAUTION: If boots adhere to spark plugs, use tool J 36011 or equivalent to remove by first twisting and then pulling upward on retainers.
Reinstall boots and retainers on ignition coil housing secondary terminals. Boots and retainers must be in place on ignition coil housing secondary
terminals prior to ignition coil and electronic ignition control module assembly installation or ignition control system damage may result.
4. Remove the ignition coil and the electronic ignition control module assembly from the engine.
INSTALL OR CONNECT
1. Install the spark plug boots and the retainers to the housing.
