Achieva L4-144 24L DOHC VIN T SFI (1996) Crankshaft Position Sensor Component Diagrams
Crankshaft Position Sensor: Service and Repair
Crankshaft Sensor
REMOVE OR DISCONNECT
1. Disconnect the Crankshaft Position Sensor (CKP) sensor harness connector at the sensor.
2. Remove the CKP sensor to block bolt.
3. Remove the CKP sensor from the engine.
INSTALL OR CONNECT
NOTE: inspect the sensor O-Ring for wear, cracks or leakage. Replace if necessary. Lubricate the new O-Ring with engine oil before installing.
1. Install the CKP sensor into the block.
2. Install the CKP sensor to block bolt.
-
Tighten the bolt to 10 Nm (88 lb. in.).
3. Connect the CKP sensor harness connector.