Achieva V6-3100 3.1L MFI VIN M (1994)
6. Install the right (rear) oil pan side bolts. Use the J39505.
^
Tighten the oil pan side bolts to 50 Nm (37 ft. lbs.).
7. Install the engine mount bracket with the engine mount to oil pan. Refer to Engine Mount Bracket Replacement.
8. Lower the engine using the J28467-A, J28467-90 and J36462.
9. Install the transaxle mount lower nuts. Refer to AT Mount Replacement Automatic Transmission/Transaxle.
10. Install the engine mount lower nuts. Refer to Engine Mount Replacement.
11. Install the transaxle brace to the oil pan. Refer to AT Brace Replacement in Automatic Transmission/Transaxle.
12. Install the starter motor. Refer to Starter Motor Replacement (3100 L82 (VIN M) with PG260 F1) in Starting and Charging.
13. Install the oil level sensor wiring harness connection.
14. Connect the three-way catalytic converter pipe to the right (rear) exhaust manifold. Refer to Catalytic Converter Replacement (3100 L82 (VIN M))
in Emission Control System.
15. Lower the vehicle.
16. Remove the J28467-A, J28467-90 and J36462.
17. Install the A/C compressor. Refer to A/C Compressor and/or Bracket in Heating and Air Conditioning.
18. Install the engine mount struts to the engine. Refer to Engine Mount Strut Replacement (Left) and Engine Mount Strut Replacement (Right).
19. Fill the engine with new engine oil. Refer to Engine Oil and Oil Filter Replacement (Without Oil Cooler) or Engine Oil and Oil Filter Replacement
(With Oil Cooler).
20. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect in Starting and Charging.
