Achieva V6-3100 3.1L MFI VIN M (1994)
Fig. 24 Exploded View Of Power Rack & Pinion Assembly
1. Remove dust cover from housing, Fig. 24.
2. While holding stub shaft, remove locknut from pinion.
3. With gear centered, mark location of stub shaft notch on housing to aid in proper installation of the pinion and valve assembly.
4. Using a suitable press, press on threaded end of pinion until it is possible to remove the pinion and valve assembly from the housing.
5. Remove stub shaft dust seal, stub shaft seal, stub shaft bearing annulus assembly, then the pinion and valve assembly with spool shaft retaining
ring and valve body rings attached.
6. Using wrench, tool No. J 36343, or equivalent, remove cylinder tube assembly from housing. Mark location of fittings on housing before
removal.
