Achieva V6-3300 3.3L (1992)
not required.
5.
Remove stub shaft dust seal, stub shaft seal and stub shaft bearing annulus assembly from valve end of housing.
Installation
1.
Install annulus assembly into gear.
2.
Place seal protector, tool No. J 29810 onto stub shaft and install stub shaft seal and stub shaft dust seal over protector and into housing.
3.
While holding the stub shaft firmly, seat the locknut, torque to 26 ft. lbs.
Upper Pinion Bushing and Pinion Shaft Seal
Fig. 24 Pinion Shaft Seal & Bushing Removal
1.
Remove upper pinion bushing and seal with a hearty punch, and install new bushing, Fig. 24.
2.
Using pinion seal installer, tool No. J 29822 seat new seal in housing with seal tip facing up.
