Achieva V6-3300 3.3L (1992)
Clutch: Customer Interest
A/T - Delayed or No Engagement In Drive/Reverse
Number: 92-T-56
Corp. Ref. No.: 107105R
Date: March 1992
Section: 7, 4T60, 4T60E
Subject:
Delayed or no engagement in drive/reversed - replace input clutch piston outer seal.
Models/Years:
1991-92 Vehicles equipped with Hydra-Matic 4T60/4T60E (RPO ME9, M13) transaxle
THIS BULLETIN CANCELS AND SUPERSEDES BULLETIN 92-T-21, DATED 12/1/91.
The above condition could be caused by a rolled or cut input clutch piston outer seal. The initial comment is often a delay in drive cold. The condition
will sometimes develop into a no/delay drive or reverse cold and delay hot over a 2000-5000 mile range. If this condition is encountered, it is
recommended that the input clutch piston outer seal be replaced.
Note:
An air check of the piston as a diagnostic aid could be misleading . The seal may look good during visual inspection but should be replaced if the above
condition was present. The seal may have rolled back into proper position during disassembly.
