Alero L4-144 2.4L DOHC VIN T SFI (2000)
3. Remove the motor pack to modulator Torx(R) head screws (6).
Important: Use care when handling the motor pack. Replace the motor pack if the motor pack is dropped or damaged during handling.
4. Separate the motor pack (1) from the Hydraulic Modulator (2).
5. Remove the three modulator drive gear retaining nuts.
6. Remove the gears from the modulator.
Installation Procedure
1. Position the modulator drive gears onto the modulator drive shaft.
Notice: Do not allow gear to turn while removing the retaining nut, since the modulator piston can hit the top of the modulator bore, damaging the
piston. Place a screwdriver through the holes in the gears (not between the gears) into the recessed hole in the modulator base. This will prevent
the gear from turning, aiding in gear removal.
2. Install the three gear retaining nuts.
^
Tighten the nuts to 8.5 Nm (76 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
