Alero L4-144 2.4L DOHC VIN T SFI (2000)
movement stops.
The procedure causes the following conditions:
^
The pistons are positioned very close to the top of the modulator bore.
^
The brake bleeding procedure is simplified.
4. Install the ABS brake motor pack (1) onto the brake modulator assembly (2).
5. Install the four Torx(R) head screws (6) that retain the motor pack (1) to the brake modulator (2).
^
Tighten the four Torx(R) head screws to 5 Nm (44 inch lbs.).
6. Install the gear cover (4) to the brake modulator assembly (2).
7. Install the Torx(R) head screws (5) that retain the gear cover (4).
^
Tighten the Torx(R) head screws to 4 Nm (36 inch lbs.).
8. Install the brake modulator assembly. Refer to Brake Modulator Assembly Replacement
9. Perform the A Diagnostic System Check - ABS.
Brake Solenoid Valve Replacement
Removal Procedure
1. Remove the Battery.
2. Remove the battery tray.
3. Disconnect the brake solenoid valve electrical connector.
4. Remove the Torx(R) head bolts (1).
Important: Verify that the brake solenoid valve lip seal (3) is still attached to the brake solenoid valve (2) when removing the brake solenoid
valve. If the seal is not attached, inspect the brake solenoid valve bore in the brake modulator (4).
