Alero L4-144 2.4L DOHC VIN T SFI (2000)
1. Remove the battery tray.
2. Clean the brake fluid reservoir cover and the surrounding area.
3. Remove the brake fluid reservoir cover.
4. Inspect the brake fluid reservoir level. Refer to Master Cylinder Reservoir Filling. Add clean brake fluid as required.
5. Connect the J35589 to the brake fluid reservoir.
6. Install the J29532 to the pressure bleeding equipment
7. Adjust the pressure bleed equipment to 242 kPa (35 psi).
Notice: Refer to Fastener Notice in Service Precautions.
8. Bleed the brake pipe connections on the brake proportioning valve using pressure bleeding equipment that is connected and pressurized:
8.1.
Slowly open the tube nut on the bottom brake pipe on the brake proportioning valve. Inspect for air in the escaping fluid.
8.2.
When the air flow ceases, immediately tighten the tube nut.
^
Tighten the tube nut to the proportioning valve 23 Nm (17 ft. lbs.).
8.3.
Moving from the bottom to the top, repeat the previous step for the top brake pipe connection.
