Alero L4-144 2.4L DOHC VIN T SFI (2000)
29.2.
When finished, perform the motor rehome procedure in order to ensure the pistons are in the upmost position. Do not drive the vehicle.
29.3.
If a scan tool is not available, remove your foot from the brake pedal, then start the engine. Allow the engine to run for at least 10 seconds
in order to initialize the ABS. Do not drive the vehicle.
29.4.
After 10 seconds, turn off the ignition.
30. Repeat the initialization procedure 5 times in order to dislodge any air in the system.
31. Repeat the manual bleeding procedure, starting at Step 1.
32. Perform a vehicle road test. Make several normal (non-ABS) stops from a moderate speed in order to ensure proper brake system function.
