Alero L4-144 2.4L DOHC VIN T SFI (2000)
1. Install the following items to the caliper (2):
^
The brake hose bolt
^
The hose (1)
^
The 2 new washers Use new washers.
Notice: Refer to Fastener Notice in Service Precautions.
2. Lubricate the bolt threads with brake fluid.
^
Tighten the brake hose caliper bolt to 54 Nm (40 ft. lbs.).
3. With the weight of the vehicle on the suspension, install the brake hose into the bracket. Ensure that there are no kinks in the hose. Align the hose
fitting with the notch in the bracket. Use the hose paint stripe as a visual aid.
4. Install the retainer onto the hose fitting at the bracket (1).
5. Connect the brake pipe to the brake hose:
^
Use a backup wrench on the hose fitting.
^
Do not bend the bracket or pipe.
^
Tighten the brake pipe tube nut to 23 Nm (17 ft. lbs.).
6. Install the front tire and the front wheel.
7. Ensure that the hose does not make contact with any part of the suspension. Check the hose in extreme right and extreme left turn conditions. If the
hose makes contact, remove the hose and correct the condition.
8. Lower the vehicle.
9. Bleed the brakes. Refer to Hydraulic Brake System Bleeding.
