Alero L4-144 2.4L DOHC VIN T SFI (2000)
1. Install the Brake Motor Pack (1) to the Hydraulic Modulator (2).
Notice: Refer to Fastener Notice in Service Precautions.
Important: Use care when handling the motor packs. Replace the motor packs if the motor packs are dropped or damaged during handling.
Align each of the three motor pack pinions with the modulator gears.
2. Install the Torx(R) screws (6) that attach the Brake Motor Pack (1) to the Hydraulic Modulator (2).
^
Tighten the Torx(R) head screws to 5 Nm (44 inch lbs.).
3. Install the gear cover to the Brake Motor pack.
4. Install the Torx(R) head screws attaching the gear cover.
^
Tighten the Torx(R) head screws to 4 Nm (36 inch lbs.).
5. Install the Brake Modulator Assembly. Refer to Brake Modulator Assembly Replacement.
6. Using the scan tool, perform the Motor Rehome Procedure.
7. Perform the A Diagnostic System Check - ABS
Brake Modulator Assembly Replacement
Removal Procedure
Caution: To help avoid personal injury, due to a retained load on the brake modulator, the Gear Tension Relief function of the scan tool
must be performed prior to removal of the ABS brake modulator assembly.
