Alero L4-144 2.4L DOHC VIN T SFI (2000)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Jumper Harness Replacement- Front
Removal Procedure
1. Raise and support the vehicle on a suitable hoist. Refer to Vehicle Lifting.
2. Remove the front wheel speed sensor harness connector (5) from the front wheel speed sensor.
3. Remove the front wheel speed sensor harness attaching clips (2) from the control arm and the frame.
4. Cut the front wheel speed sensor wiring circuits within the main engine harness.
5. Strip the insulation on the engine harness leads and the new wheel speed sensor harness leads.
Installation Procedure
1. Splice the sleeve provided in the harness kit over each engine harness lead.
2. Install the new front wheel speed sensor harness leads to the engine harness leads and crimp the connections. Make sure the wire colors match.
3. Heat shrink the tube lightly to seal the connection.