Alero L4-144 2.4L DOHC VIN T SFI (2000)
^
At the cylinder block
^
At the seal housing 3 way joint
3. Repair damaged strips using Silicone Sealant GM P/N 12345739 or equivalent. Use only enough sealant in order to restore the silicone strip to its
original dimension.
4. Install the seal housing.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the bolts which secure the oil pan to the seal housing.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
6. Install a new rear crankshaft seat using J 36005.
7. Install the flywheel.
8. Install the new bolts or apply Adhesive/Sealant Compound GM P/N 12345493 or equivalent to the bolts which you are reusing.
9. Use J 38122-A and J 36660-A when installing the bolts. This will prevent crankshaft rotation.
^
Tighten the bolts to 30 Nm (22 ft. lbs.) + 45 degrees.
10. Install the transmission assembly. Refer to Transmission Replacement in Transmission and Drivetrain.
11. Connect the negative battery cable.
^
Tighten the bolt to 16 Nm (12 ft. lbs.).
12. Test the engine oil level.
13. Turn the ignition switch to the ON position.
14. Test for leaks.
