Alero L4-144 2.4L DOHC VIN T SFI (2000)
8. If any spark plug boot connector assembly has stuck to a spark plug, reinstall the connector onto the ignition coil and the module assembly.
9. Place the ignition coil and module assembly over the spark plugs and push straight down.
10. Clean any lubricant that is present on the ignition coil and on the bolts which secure the module assembly to the camshaft housing.
11. Apply Pipe Sealant GM P/N 1052080 or equivalent onto the ignition coil and onto the bolts which secure the module assembly to the camshaft
housing.
12. Install the ignition coil and install the bolts which secure the module assembly to the camshaft housing.
^
Tighten the bolts to 15 Nm (11 ft. lbs.) + 30 degrees.
13. Connect the electrical connector to the ignition coil and to the module assembly.
14. Connect the negative battery cable.
