Alero L4-144 2.4L DOHC VIN T SFI (2000)
5. Lubricate the front oil seal and the sealing surface of the crankshaft balancer with Chassis Grease GM P/N 1051344 or equivalent.
6. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement.
7. Install the right splash shield.
8. Install the right front wheel and tire assembly.
9. Lower the vehicle.
10. Install the engine mounting bracket adapter.
Notice: This bolt is designed to permanently stretch when tightened. The correct part number fastener must be used to replace this type of
fastener. Do not use a bolt that is stronger in this application. If the correct bolt is not used, the parts will not be tightened correctly. The system or
the components may be damaged.
Important: If you remove these bolts, replace with new bolts.
11. Install the engine mounting bracket adapter bolts.
^
Use J 36660-A in order to tighten the bolts to 110 Nm (81 ft. lbs.) + 90 degrees.
12. Lower the engine.
13. Install the engine mount assembly. Refer to Engine Mount Replacement.
14. Remove the J 28467-400 and the J 28467-360.
15. Install the drive belt. Refer to Drive Belt Replacement
16. Install the coolant surge tank. Refer to Surge Tank Replacement in Cooling System.
17. Add coolant. Refer to Draining and Filling Cooling System in Cooling System.
18. Connect the negative battery cable.
