Alero L4-144 2.4L DOHC VIN T SFI (2000)
12. Remove the camshaft sprocket retaining bolts and the washers while holding the sprockets with the J 36008-A.
13. Remove the camshaft sprockets. The camshaft sprockets are identical and interchangeable.
14. Remove the bolts which secure the chain housing to the camshaft housing.
15. Remove the timing chain housing and the gaskets. You may need to raise the engine slightly using the J 28467-360. Refer to Engine Support
Fixture.
16. Inspect the oil pan gasket silicone bead for the following conditions:
^
Cuts or nicks
^
Deformation
^
Separation from the aluminum carrier
17. If any of the conditions exist, replace the pan gasket.
Important: Use only enough sealant in order to restore the silicone bead to its original dimension. Excess application of sealant may cause part
misalignment and oil leaks.
18. Inspect the silicone bead across the top of the aluminum carrier at the oil pan, in the cylinder block, and to the timing chain housing 3-way joint.
Repair a damaged bead using the silicone rubber sealant GM P/N 12345739 or the equivalent.
Installation Procedure
