Alero L4-144 2.4L DOHC VIN T SFI (2000)
2. Install the pump cover bolts. Hand tighten the bolts.
3. Install the cover-to-block bolts. Hand tighten the bolts.
4. Install the coolant pump-to-timing chain housing nuts. Hand tighten the nuts.
5. Lubricate the O-ring on the coolant inlet pipe with an antifreeze solution.
6. Slide the pipe into the water pump cover.
7. Install the bolts. Hand tighten the bolts.
Notice: Refer to Fastener Notice in Service Precautions.
8. Torque in sequence as follows:
8.1.
Tighten the pump assembly-to-timing chain housing nuts.
^ Tighten nuts to 26 Nm (19 ft. lbs.).
8.2.
Tighten the pump cover-to-pump assembly bolts.
^ Tighten the bolts to 14 Nm (124 inch lbs.).
