Alero L4-144 2.4L DOHC VIN T SFI (2000)
1. Install the fuel level sensor (1) by sliding it down in the housing.
2. Slide the upper reservoir into the lower reservoir (2).
3. Connect the 2 wires into the connector and lock it with the retaining clip.
4. Connect the fuel pump and fuel level sensor electrical connector and lock with it the retaining clip.
5. Reinstall the fuel sender assembly.
6. Reinstall the fuel tank.
7. Refill the fuel tank.
8. Reinstall the fuel fill cap.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
9. Connect the negative battery cable.
10. Inspect for leaks using the following procedure:
10.1. Turn ON the ignition for 2 seconds.
10.2. Turn OFF the ignition for 10 seconds.
10.3. Turn ON the ignition.
10.4. Inspect for fuel leaks.
