oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

Inflator Module Replacement|Page 10136 > < Inflator Module Replacement|Page 10134
Page 5
background image

38. Separate the two ends of the passenger deployment harness wires.
39. Connect the passenger deployment harness wires to the power source in order to deploy the inflatable restraint IP module.
40. Disconnect the passenger deployment harness wires from the power source.

41. Twist together one end of each wire on the driver deployment harness in order to short the wires.

42. Twist together one end of each wire on the passenger deployment harness in order to short the wires.
43. Remove the drop cloth from the vehicle.
44. Disconnect both harnesses from the vehicle.
45. Discard the harnesses.
46. Scrap the vehicle in the same manner as a non-SIR equipped vehicle.
47. If one or both of the modules did not deploy, perform the following steps:

47.1. Remove the undeployed module(s) from the vehicle. 
47.2. Temporarily store the module(s).
47.3. Call the Technical Assistance Group for further assistance.

Inflatable Restraint Instrument Panel Module

TOOLS REQUIRED

^

J 39401-B SIR Deployment Fixture

^

J 38826 SIR Deployment Harness

^

An appropriate pigtail adapter

CAUTION: 

^

In order to prevent accidental deployment of the air bag which could cause personal Injury, do not dispose Of an undeployed inflator

Inflator Module Replacement|Page 10136 > < Inflator Module Replacement|Page 10134