Alero L4-144 2.4L DOHC VIN T SFI (2000)
5. Tape over the entire cable. Use a winding motion when you apply the tape.
Wire Size Conversion Table
Flat Wire Repairs
NOTE: The flat wire within the flex wiring harness is not serviceable. If an open or short exists within the flex wiring harness the complete harness
must be replaced.
Pull to Seat Connectors
TERMINAL REMOVAL
Follow the steps below in order to repair push to seat connectors.
1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
2. Separate the connector halves (1).
3. Use the proper pick or removal tool (1) in order to release the terminal.
4. Gently pull the cable and the terminal (2) out of the back of the connector.