Alero L4-144 2.4L DOHC VIN T SFI (2000)
1.
Route the electrical connectors (4) through the steering wheel opening.
2.
Connect the electrical connector (4) to the steering column (3).
3.
Install the steering wheel on the steering column (3).
Notice:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints,
lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping
force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts
and systems.
4.
Install the steering wheel nut (1) on the steering column (3).
Tighten the nut to 37 N-m (27 lb ft).
5.
Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
6.
Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement On-Vehicle.
7.
Enable the SIR system. Refer to Enabling the SIR System in SIR.
8.
Connect the negative battery cable.
