Alero L4-144 2.4L DOHC VIN T SFI (2000)
6. Clean and inspect the seal bore.
7. Use fine sand paper in order to remove any burrs or nicks. Clean the entire area after any sanding.
Installation Procedure
^
Tools Required
-
J 41228 Stub Shaft Seal Installer
-
J 41102 Case Cover Seal Installer
1. Use the J 41102 and a mallet in order to install the new case cover seal.
2. Use the J41228 in order to install a new sleeve on the output axle. Install the J 41228 so that the collar is in the snap ring groove.
3. Install the axle shaft retaining clip onto the output axle.
4. Install the drive axle assembly. Refer to Wheel Drive Shafts Replacement.
5. Lower the vehicle.
