Alero L4-144 2.4L DOHC VIN T SFI (2000)
Fluid - A/T: Testing and Inspection
4T40-E/4T45-E Adding Transaxle Oil
Important: If fluid drains through the screw hole the transaxle may have been overfilled. When fluid stops draining the fluid level is correct and
check plug may be installed. If fluid does not drain through the screw hole the transaxle fluid level may have been low. Add fluid at the vent cap
location in half liter (1 pint) increments until oil level is at the bottom of oil check hole.
1. Install oil check plug.
Tighten
-
14 Nm (124 inch lbs.).
2. Lower vehicle.
