Alero L4-144 2.4L DOHC VIN T SFI (2000)
2. Install the axle shaft to the steering knuckle (2).
3. Install the ball joint to the steering knuckle. Refer to Lower Ball Joint Replacement in Steering and Suspension.
4. Connect the stabilizer link. Refer to Stabilizer Shaft Link Replacement in Steering and Suspension.
5. Insert a drift (1) into the caliper and rotor in order to prevent the rotor from turning.
Notice: Refer to Fastener Notice in Service Precautions.
This article has been updated with TSB 03-04-18-001.
NEW FRONT DRIVE AXLE NUT
Use the new nut, P/N 10289657, whenever the front drive axle nut is removed. This new nut is a torque prevailing nut and is silver in color. The
old nut is black in color and has a sheet metal cage around the nut (shown below). Using the new nut will provide a more consistent clamp load on
the wheel bearing and should help prolong the bearing life.
NOTICE: Use the correct tightening specifications when installing fasteners in order to avoid damage to parts and systems.
