Alero L4-144 2.4L DOHC VIN T SFI (2000)
41.
Inspect the new shifter assembly for the following (refer to Figure 4):
^
Ensure that the shifter neutral position U-clip is pushed all the way in. If it isn't, find the neutral position between 3rd and 4th gear and push the
U-clip in while moving the shifter handle very slightly. The U-clip should be close to the shifter assembly body.
^
The shift cable retainers are in the open position.
42.
Position the shifter to the floor of the vehicle and install the front and the rear shifter mounting nuts. Remember to position the console mounting
bracket onto the rear shifter mounting studs. DO NOT HOOK UP THE SHIFT CABLES AT THIS TIME.
Tighten
Tighten the nuts to 25 Nm (18 lb ft).
