Alero V6-3.4L VIN E (1999)
3. Install the park/neutral position switch mounting bolts.
^
Tighten the bolts to 24 Nm (18 ft. lbs.).
4. Connect the negative battery cable.
5. Ensure that the engine will only start in the P (Park) or the N (Neutral) position. Readjust the switch if the engine will start in any other position.
Using New Switch
1. Place the shift shaft in the N (Neutral) position.
2. Align the flats of the shift shaft to the flats in the switch.
3. Install the park/neutral position switch assembly.
4. Install the park/neutral position switch mounting bolts.
^
Tighten the bolts to 24 Nm (18 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the lever.
6. Install the shift linkage.
