Aurora V6-214 3.5L VIN H SFI (2001)
12. Remove the fog lamps from the fascia. Refer to Front Fog Lamp Replacement .
Installation Procedure
1. Install the fog lamps to the fascia. Refer to Front Fog Lamp Replacement .
2. Install the energy absorber to the front bumper fascia. Refer to Front Bumper Fascia Energy Absorber Replacement (See: Front Bumper Shock
Absorber/Service and Repair).
3. Hand start the fasteners (1, 2) into the front bumper fascia.
4. Align the front bumper fascia (3) and the front energy absorber to the front impact bar.
Notice: Refer to Fastener Notice in Cautions and Notices.
5. Insert the fasteners (2) into the keyhole slots in the front fenders.
Tighten the fasteners, bolt (1) to 9 Nm (80 lb in).
6. Install the push pin retainers (3) to secure the front bumper fascia to the upper filler panel.
7. Connect the fog lamp electrical connectors.
8. Install the push pin retainers to secure the front bumper fascia to the front wheelhouse extensions.
9. Install the push pin retainers to secure the front bumper fascia to the air deflector.
10. Lower the vehicle.
11. Close the hood.
