Aurora V6-214 3.5L VIN H SFI (2001)
Important: Note the routing of the wiring harness for reinstallation, failure to route the wiring harness properly could result in damage
to the wiring.
9. Disconnect the electrical connectors from the power seat switches.
10. Use a flat bladed tool in order to remove the switch from the bracket.
Installation Procedure
1. Install the power seat switch into the switch bracket.
2. Install the wiring harness in the position in which it was removed.
3. Connect the electrical connectors to the power seat switches.
4. Slide the bracket with the switches upward into the seat cushion frame.
5. Install the retainers in order to secure the bracket and switches to the seat cushion frame.
6. Install the seat cushion cover over the switches aligning the holes in the cover to the switch assembly.
7. Position the power seat switch bezel over the switches.
8. Install the power seat switch bezel fasteners.
9. Install the power seat switch knobs (1).
10. Install the seat cushion. Refer to Front Seat Cushion Replacement (See: Seat Cushion/Service and Repair/Front Seat Cushion Replacement).
11. Enable the SIR system. Refer to Enabling the SIR System in SIR.
