Aurora V6-214 3.5L VIN H SFI (2001)
9. Remove the 6 EBCM to BPMV screws (2).
10. Clean the surface of the EBCM/BPMV assembly.
Important: The EBCM cannot be repaired. If faulty, the unit must be replaced.
11. Separate the EBCM (2) from the BPMV (1).
Installation Procedure
1. Clean the seal surface of the Brake Pressure Modulator Valve (BPMV).
2. Install the Electronic Brake Control Module (EBCM) (2) to the BPMV (1).
Notice: Refer to Fastener Notice in Service Precautions.