Aurora V6-214 3.5L VIN H SFI (2001)
2. Install the booster stud mounting nuts.
Tighten the brake pedal to booster stud mounting nuts to 23 Nm (17 ft. lbs.).
3. Install the brake pedal to cowl studs mounting nuts.
Tighten the brake pedal to cowl studs mounting nuts to 16 Nm (12 ft. lbs.).
4. Apply lubricant, GM P/N 1050109 or equivalent, to brake pedal clevis pin.
5. Install the pushrod onto brake pedal clevis pin.
6. Install the brake pedal foam spacer to the brake pedal clevis pin.
7. Install the pushrod retainer to the brake pedal clevis pin.
8. Install the accelerator control cable.
9. Install the electrical connectors to the stoplamp/ABS/shift lock switch (2).
10. Install the stoplamp/ABS/shift lock switch (2).
11. Install the TCC/cruise control release switch.
12. Install the IP assembly.
