Aurora V6-214 3.5L VIN H SFI (2001)
17.
Install the bleeder valve and cap to the caliper and tighten the valve securely.
18.
Install the front brake caliper to the vehicle.
Rear Brake Caliper Overhaul Procedure
(See Vehicles Listed Below)
^
1999-2001 Buick Regal
^
1999-2001 Buick Regal (Export China)
^
2000-2001 Chevrolet Impala, Monte Carlo, Trans Sport (Export China)
^
1998-2001 Oldsmobile Intrigue
^
1997-2001 Pontiac Grand Prix
Caution:
Do not place fingers in front of the caliper piston(s) in an attempt to catch or protect it when applying compressed air. The piston(s) can fly out with
force and could result in serious bodily injury.
Notice:
Use clean cloths to pad the interior of the caliper housing during piston removal. Use just enough air to ease the piston out of the bores. If the pistons
are blown out, even with the padding provided, it may be damaged.
1.
Remove the rear brake caliper from the vehicle.
2.
Remove the bleeder valve and cap from the caliper housing.
3.
Remove the brake caliper piston from the caliper bore by directing low pressure compressed air into the caliper bore through the fluid inlet hole.
4.
Remove the retaining ring that secures the dust boot to the caliper housing.
