Aurora V6-214 3.5L VIN H SFI (2001)
Parking Brake Pedal: Service and Repair
Manual Adjustment System
Park Brake Pedal Assembly Replacement (Manual Adjustment System)
Removal Procedure
The manual adjustment park brake pedal assembly and the front park brake cable are serviced as separate units. The front park brake cable uses a
threaded equalizer for adjustment.
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Loosen and disconnect the front park brake cable at the adjuster.
3. Lower the vehicle.
4. Remove left closeout insulator panel to access lever assembly.
5. Remove the left front carpet retainer.
6. Pull back carpet to expose park brake cable.
7. Disconnect the electrical connector from the park brake warning switch.
